How to apply laptop decal


Step 1.
Wash hands with soap and warm water to remove any natural oils and grease.
Dry hands thoroughly.
Firmly run a credit card across the transfer tape to remove any crease or bubbles.
 
Step 2.
Wipe your device to remove dust and dirt with water and a damp towel.
Using a dry towel, make sure there's no water left on your device.
Let it sit for a few minutes to make sure any leftover water has evaporated.
 
Step 3.
Cut along the dotted line with a scissor and separate the instructions from the decal.
-------✂️---------------
 
Step 4.
Place the decal face down.
Carefully peel the backing paper from the decal at a sharp angle.
 
Also carefully remove the excess border from the decal. (Use a paperclip or a pin at the corner if necessary).
 
Step 5.
Alight the decal.
Once you're happy with the alignment of your decal, press the decal to your device.
If a crease or small air bubbles form, don't worry, the channeled Controlac 3M adhesive allows for creases and bubbles to be pressed and smoothed away.
Firmly run a credit card across the transfer tape to make sure the decal adheres to the surface.
 
Step 6.
Slowly peel the transfer tape from the top of the decal.
If any part of the decal starts to come up with the tape, run over that part of the decal with a credit card and try to peel the tape again.
 
help@merchdirect.com
http://assets2.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete